Mobile Blending Unit

The Dragon 100 Barrel Blender is designed to integrate a slurry of water, sand, dry chemicals and liquid chemicals to provide the desired fracturing components.

• Maximum working Fluid Rate: 100 BPM (4200 GPM)
• Maximum Discharge Pressure: 80-100PSI
• Dimensions: (dimensions may change depending on chosen chassis)
• Length with sand hopper up: 43’-3” (13.2m) down: 44’-11” (13.7m)
• Width: 8’-2” (2.5m) • Height: 12’-4” (3.8m) • Weight: 55,000 lbs (24,950 kg)

CHASSIS SPECIFICATIONS:

• Steel rear dual axle fenders
• Front & Rear oil-field bumper with tow loops
• LED chassis lights and work lights

POWER UNITS:

• Road motor 605Hp with FABCO Transfer case
• 375 HP John Deere deck engine with (4) Pad Funk Drive & 100 Gallon Fuel Tank

SUCTION/DISCHARGE PUMPS:

• 12″ x 12″ centrifugal pump (suction)
• 12” Suction and Discharge Manifolds with (12) 4” 206 subs
• 8”  MAG Flow-Meter on Suction Piping
• 12″ x 14″ Centrifugal pumps (Discharge)
• 8” MAG Meter on Discharge Piping with
• Pre-Fabricated Blank to Add a Turbine
• Flow-Meter

HYDRAULIC SYSTEM:

• Hydraulic Auger Positioning System
• Hydraulic oil cooler with 160 gal
• Hydraulic oil reservoir
• Close Circuit Hydraulic Pumps for Augers and Suction Pump
• Hydraulic Pump for Auxiliary Functions
• Hydraulic Hoses

BLENDING SYSTEM:

• 72” Mixing tub with Impeller (16 BBL Volume)

• Dual 12” hydraulically driven sand augers
• Single 6” hydraulically driven sand auger
• Large in-feed hopper

DRY-ADD SYSTEM:

• Dry-add hoppers with 4” auger and jet mixer
• Dry -add hopper with 2″ auger and jet mixer

CONTROL PANEL:

• Full-Control and Storage Deck
• Air-Actuated Tub Drain
• Steel Control Panel
• Gauges and Controls Include:
• Engine Start/Stop/Throttle, Display Modules with Hours, Fault Codes, Oil Pressure and Coolant Temperature
• Auger Speed Controls and FWD/REV Switches
• Liquid Chemical Pump Speed Controls with Flow/Total Displays
• Two Dry Chemical Feeder Speed Control with Flow/Total Displays
• Tub Paddle Speed Control
• Auger Lift Control
• Engine Kill Switches
• Light Switches
• Hydraulic Temperature and Pressure Gauges
• Suction Pump Hydraulic Pressure Gauge
• Auger System Hydraulic Pressure Gauge
• Suction/Discharge Pump Speed Controls with Flow/Total Displays

OPTIONAL EQUIPMENT:

• Mounting Racks on Back Bumper
• Wash down spray hose
• Additional Hose Racks
• Operator Enclosure with Heating and A/C
• Chemical Add System

PAINT:

Paint color specification to be supplied by customer, two color maximum. Additional colors are available for an additional charge.