Previous
Next
3 Axle Removable Neck Trailer
3-Axle Removable Gooseneck Trailers
SPECIFICATIONS
- Type: Low Profile Level Deck with removable neck.
- Payload: 50 tons (100,000 lb) distributed over 16 ft.
- Overall length: 56’-7”
- Deck length: 42’-0”
- Deck width: 8’-6” (102”)
- Deck height: 3’-5” (41”)
50 TON 3 AXLE HEAVY HAUL TRAILER
- Deck Camber: 1-1/2” nominal, neck to first axle
- King Pin settings: 16” and 34”
- Swing Clearance: 8’ – 6” (102”) and 10’ -0” (120”)
- Frame: 4 beam design. Fabricated beams from a A514 T-1 high tensile steel flanges and webs. Main beams boxed reinforced at critical deck transition, 2-1 minimum safety factor at maximum payload stresses
- Front Deck: 27’-9” L, 2” apitong attached at ends and every other crossmember.
- Rear Deck: 14’ – 3” L including tail roller, 1/4” steel plate deck, continuous welds on top, intermittent welds on under side
- Neck: Mechanical removable with roller at rear, 2 King Pin locations, spare tire carrier each side (spare tires optional)
- Rear Deck Roller: 8” SCH 160 pipe (8 5/8” OD) with double spherical bearings, 2 sets of over load rollers, grease fittings on main roller and overload rollers
- Neck Roller: 6” SCH 160 pipe (6-5/8” OD) with double spherical bearings, grease fittings, cable guide flanges
- Deck Load Rollers: 6” sch 160 pipe (6-5/8” OD) with double spherical bearings, grease fittings, air operated to raise, spring load to lower, used to assist in unloading skidded loads off the rear
- Pin Pockets: 1 each side at rear on 45 degree angle with 1/2” grab hooks, (2) 3“ id each side in main deck inside outer beam, 6 each side on outside of outer beam
- D Rings: 16 on each side, outside of outer beam, 2 inside of neck
- Outriggers: 13 each side, forged heavy duty, locking against beam and at 90 degrees to beam
- Traction Cleats: 3/4” x 1” A514 T-1 steel, continuous welds solid on up hilltop, intermittent welds on downhill side
- Suspension: 30,000 lb. (per axle) air ride, air lift on front axles, manual dump all axles, travel limit straps on all axles
- Axles: 3 – 25,000 lb. round with outboard drums
- Wheels: 10 hole steel disc hub pilot
- Axles: 5 -25,000 lb. round with outboard drums
- Tires: 255R/70 x 22.5 Radial
- Brakes: 16 1/2 x 7, spring parking brakes on 4 axles, auto slack adjusters
- Bumper: 4” SCH 80 pipe with 4 – D rings
- Mud Flaps: Anti Sail
- Lights: Full DOT lights, sealed led lights
- Coating: All surfaces near white metal steel grit blast, 2.5 ml profile (SP-6), primed and color coated {before decking) with high solids polyurethane, 4-6 ml dry film thickness