Cementer Mixer & Pumping Truck

MIXING AND PUMPING OPERATION COMPONENTS:

• Twin CAT C-15 Diesel Engines, 595 Hp with CX31-P600 Transmission
• CAT C-7 Diesel Engine, 275 HP with integral 4-Pad Funk PTO Drive
• (2) AXON HD500 Triplex Pumps
• High Energy Re-Circulating Jet Mixer and Diffuser
• 10 BBL Mixing Tank (2) sections with (2) Agitators
• 20 BBL Displacement Tank (2) 10 BBL sections (with markers)
• (2) Dragon 6 x 5 x 11 Centrifugal Pumps (Boost and Recirculation)
• (2) Dragon/Mission 3 x 4 Centrifugal Pumps (Mix Water and redundant)
• 3” Densitometer in the Re-Circ mixing line

Twin 600 Cementer

HYDRAULIC POWER COMPONENTS:

• CAT C-7 Diesel Engine, 275 Hp with integral 4-Pad Funk PTO Drive
• Air compressor, air tank and air system complete with air filter, air dryer, air-water separator

        and all necessary valves and hoses.

• (4) Sauer-Danfoss Series 90 Pumps (closed loop hydrostatic for C-Pumps)
• (4) Sauer-Danfoss Series 90 Hydraulic Motors (closed loop hydrostatic for C-Pumps)
• Sauer-Danfoss Series 45 Load Sense work function pump
• Sauer-Danfoss PLUS+1™ Electronic Controls (with Manual Back-up)
• Fine Tuning Flows with 3-turn Rheostats
• Hydraulic oil reservoir and hydraulic cooler

DIMENSIONS:

Height – 13’ (4 m), Length – 44’ (13.4) Width – 8’-6” (2.6 m)

HEAVY DUTY FRAME:

Single Drop Deck Tri-Axle Unit with Fifth Wheel towing arrangement.

PUMPING SYSTEM DIESEL ENGINE:

Two CAT C15 diesel engines on the unit, each rated for 600 HP at 2100 rpm

TRANSMISSION:

Installed on the rear of each engine is a Caterpillar CX31-P600 transmission.

DRIVELINE:

Each Transmission is connected to the pump via a heavy duty drive line installed at an angle no greater than as specified by the manufacturer with a metal guard with suitable access points for greasing and maintenance of the yokes.

FLUID HANDLING SYSTEM DISPLACEMENT TANKS:

Installed above the transmissions is a dual compartment tank with a capacity of 22 Barrels. The tanks are oriented so that the operator can view the entire tank volume from the operator’s platform.

MIXING TANK:

• High energy re-circulating mixer
• Bulk air separator (diffuser)
• Bulk cementing metering valve
• 10 BBL Steel Mixing tank with agitator and hydraulic motor, speed controlled
• (2) sections, Boost and Recirculate

CONTROL PANEL:

Full control and storage deck with covered aluminum control panel.

OPTIONAL EQUIPMENT:

• Density Control System, Tub level Control System, Absolute Density Measurement System,

       Data Acquisition Systems

• 130° F Cooling Package

Note: We have different options as to the pump based on customer specifications.